Pioneer DVR-231-S Operating Instructions Manual page 24

04 Getting started
STANDBY/ON to switch the recorder into
• Press
standby.
Playing DVD discs
The table below shows the basic playback controls for
DVD-Video, and recordable DVD discs.
Press to start or restart playback.
If RESUME is
back starts from the place last stoppe
Press to pause playback; press again to
restart playback.
Press to stop playback.
You can resume playback from the same
point by pressing
cancel the resume function.)
• During playback, press to start scan-
ning. Press repeatedly to increase the
scanning speed.
• Press an
slow-motion playback. Press repeate
change the playback spee
• While paused, press to advance a single
frame in either direction.
Press to skip to previous/next chapter/title.
(You can also use the front panel
tons to do this during playback.)
(Commercial skip). Each press skips for-
CM SKIP
ward progressively up to a maximum of
ten minutes.
• Except VR mode: during playback, enter a
1 2 3
chapter number then press
4 5 6
directly to that chapter within the currently
7 8 9 0 playing title.
On some discs, you can also use the num-
ENTER
ber buttons to select numbered items in
the disc menu.
• VR mode only:
title number then press
• All: Press
entry and start again.
Press to display the 'top' menu or menu of
a DVD-Video disc (these are often the
TOP MENU MENU
same).
Use the cursor buttons to navigate DVD-
Video disc menus; press
ENTER
items.
Press to return to the previous level of a
RETURN
DVD-Video disc menu.
24
En
d d
isplaye on-screen, play-
d
. (Press again to
d d
hol while paused to start
d ly to
d
.
+/–
but-
ENTER
to skip
d uring playback, enter a
ENTER
.
CLEAR
to clear a number
ENTER
to select
Playing audio CDs
The table below shows the basic playback controls for
audio CDs.
Press to start playback.
Press to pause playback; press again to
restart playback.
Press to stop playback.
.
Press to start scanning. Press again to
increase the scanning spee
two scan spee
is shown on-screen.)
Press to skip to previous/next track. (You
can also use the front panel +/– buttons to
d
o this
D
uring playback, enter a track number
1 2 3
then press
4 5 6
track.
7 8 9 0
Press
start again.
ENTER
Note
• If you want to play a DTS audio CD, make sure the
recorder is connected to a DTS-compatible amp/
receiver with a digital connection. Noise will be
output through the analog outputs. Also make sure
that STEREO is selected using the AUDIO button
(see Switching audio channels on page 32).
Playing Video CDs
The table below shows the basic playback controls for
Video CDs.
Some discs feature Playback Control (PBC for short)
menus. These discs show PBC in the display when you
load them and display a menu on-screen from where you
can select what to watch.
Press to start or restart playback.
If RESUME is
back starts from the place last stoppe
Press to pause playback; press again to
restart playback.
Press to stop playback.
You can resume playback from the same
point by pressing
cancel the resume function.)
d . (There are
d
s; the current scan spee
d
uring playback.)
ENTER
d
to skip irectly to that
CLEAR
to clear a number entry an
d d
isplaye on-screen, play-
. (Press again to
d
d
d .