Table of Contents
Advertisement
en | 1 6 | User guide | OBD 2220 Info Scan
4.8
Locating Data Link Connector
•
The OBDII data link connector (DLC) is usually
located under the driver's side dash.
•
Refer to vehicle user manual for DLC location.
4.9
Connect the Tool
1.
Locate the OBDII data link connector (DLC) under
the steering column. If the connector is not there, a
label should be there indicating the whereabouts of
the connector.
2.
If necessary, remove the cover from the vehicle
connector.
3.
Turn the ignition switch to the ON position. Do not
start the engine.
4.
Plug the OBDII connector attached to the tool into
the DLC.
5.
The tool will attempt to identify the vehicle. If suc-
cessful, the vehicle identified will be displayed. If
vehicle couldn't be identified, menus will be shown
for you to select the vehicle manually.
The tool can support one previous vehicle in the
garage. If you already have a previous vehicle in your
garage, the tool will automatically overwrite the
previous vehicle with the currently selected one. All
previous scanned data in Review Data will be a
combination of all previous vehicles. Run all func-
tions again to ensure that all data was scanned from
the current vehicle.
6.
Review Quick Test results.
7.
Go to Diagnostic Menu by pressing
4.10
Vehicle Selection
If the scan tool failed to identify the vehicle, or if
was pressed from the Diagnostic Menu, the Vehicle
Selection screen will appear.
1.
Use the
and
Manual or Prev:.
•
If the vehicle does not support AutoID™, select
Manual and go to Step 3.
•
If the previously tested vehicle listed after Prev:
is desired, select Prev:. If this is the first time
the tool has been used, the space after Prev:
will be blank.
•
Press
.
580000 | REV. A | 04.2017
.
keys to select AutoID™,
Select Vehicle
AutoID (>=2000)
Manual (<=1999)
Prev: 06 Lancer
2000-04 vehicles may support Aut
•
A Turn Key Off screen will display.
Turn Key Off
Please turn the key off for
10 seconds then turn the key
Press ENTER
2.
After 10 seconds, turn key ON.
•
If the vehicle is supported, the VIN number and
essential vehicle data will display.
Select Vehicle
Pre: 06 Lancer
Is this correct?
No
3.
Use the
or
key to select YES or NO.
•
If YES is selected, the Tool may display more
selections to further select the vehicle because
not every aspect of vehicle identification is
contained in the VIN.
•
If NO is selected, the Tool proceeds to manual
selection.
•
Press
.
4.
If Manual was selected in Step 1, use the
keys to select:
•
OBDII/EOBD
•
US
•
Europe
•
Asia
•
Prev:
on.
to continue
Yes
and
Bosch Automotive Service Solutions Inc.
Hide quick links:
Advertisement
Table of Contents
