GE 239 Instruction Manual page 42

4 PROGRAMMING
SEE PREVIOUS PAGE
] PROGRAMMABLE
] MESSAGE
MESSAGE L
MESSAGE M
] PRODUCT OPTIONS
]
4
MESSAGE L
MESSAGE M
] END OF PAGE S1
]
a) PREFERENCES
• TEMPERATURE DISPLAY: Select whether temperatures should be displayed in degrees Cel-
sius or Fahrenheit. Temperature units can be changed at any time.
• DEFAULT MESSAGE TIME: Up to 5 default messages can be selected to automatically scan
sequentially when the 239 is left unattended. If no keys are pressed for the default message time
set with this setpoint, then the currently displayed message will automatically be overwritten by
the first default message. After 5 seconds, the next default message in the sequence will display
if more than one is selected. Alarm and trip messages will over-ride default message display. Any
setpoint or measured value can be selected as a default message. Refer to Section 3.6:
DEFAULT MESSAGES on page 3–6 for information on removing and adding new default mes-
sages.
Default messages can be disabled by setting this setpoint to 2)) . When this setpoint is turned off,
the currently displayed message will remain displayed until a condition such as a trip alarm, or
key press forces the 239 to display a different message.
4-4
Courtesy of NationalSwitchgear.com
MESSAGE 4
Phone: (905) 294-6222
GEindustrial.com/pm
MESSAGE 3
MESSAGE 4
SELECT OPTIONS TO
ENABLE: NONE
SELECT MOD 1 TO
MESSAGE 3
ENABLE: 0
SELECT MOD 2 TO
ENABLE: 0
SELECT MOD 3 TO
ENABLE: 0
SELECT MOD 4 TO
ENABLE: 0
SELECT MOD 5 TO
ENABLE: 0
Figure 4–2: SETPOINTS PAGE 1 – 239 SETUP
239 Motor Protection Relay
Range: 40 Alphanumeric characters
Range: NONE, RTD, AN, RTD-AN
Range: 0 to 999
Range: 0 to 999
Range: 0 to 999
Range: 0 to 999
Range: 0 to 999
Passcode obtained from factory.
ENTER PASSCODE:
4 PROGRAMMING
GE Multilin