Epson Artisan 810 Service Manual page 177

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Be careful of the following when installing the ADF Motor Unit.
Route the ADF Motor cable, the ADF Sensor cable and the
grounding wire as shown below.
ADF Motor Unit
Figure 4-149. Routing the cables
Attach the torsion spring from under the ADF EJ Roller.
Figure 4-150. Attaching the torsion spring
Insert the shaft of the ADF Motor Unit to the hole of the ADF
Frame Unit as shown in
DISASSEMBLY/ASSEMBLY
ADF Motor cable
ADF Sensor cable
Grounding wire
Torsion spring
ADF EJ Roller
Fig. 4-148.
When placing the cables on the ADF Cable Cover, route them
as shown below.
Disassembly Procedures
ADF Cable Cover
ADF Motor cable
Grounding wire
Acetate tape
Figure 4-151. Routing the cables in the ADF Cable Cover
Revision G
ADF Sensor cable
Align the edge of the
acetate tape to the edge
of the ADF Cable Cover.
177
Confidential