Page 3
158865/JAN95 5/20/02 3:47 PM Page 4 IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY WALT TOOL, CALL US TOLL FREE AT 1-800-4-D WALT (1-800-433-9258). 1/2" KEYLESS CHUCK Serial Number from Nameplate Date of Purchase Save this information for future reference MULTI-POSITION SIDE HANDLE WALT…BUILT JOBSITE TOUGH...
158865/JAN95 5/20/02 3:47 PM Page 1 WARNING: When using electric tools, basic safety Safety Instructions For All Tools precautions should always be followed to reduce risk of fire, • KEEP WORK AREA CLEAN. Cluttered areas and benches electric shock, and personal injury, including the following: invite injuries.
Page 5
158865/JAN95 5/20/02 3:47 PM Page 2 Minimum Gage for Cord Sets • SECURE WORK. Use clamps or a vise to hold work. It’s Volts Total Length of Cord in Feet safer than using your hand and it frees both hands to operate 120V 0-25 26-50...
158865/JAN95 5/20/02 3:47 PM Page 3 THE VARIABLE SPEED TRIGGER SWITCH permits speed control – the farther the trigger is depressed, the higher the speed of the drill. NOTE: Use lower speeds for starting holes without a center punch, drilling in metal or plastics, driving screws or drilling ceramics.
158865/JAN95 5/20/02 3:47 PM Page 4 4. Always apply pressure in a straight line with the bit. Use enough pressure to keep drill biting, but do not push hard enough to stall the motor or deflect the bit. FIG. 3 5.
Page 8
158865/JAN95 5/20/02 3:47 PM Page 5 Side Handle FIG. 4 TURN OFF AND UNPLUG DRILL. CAUTION: Always use side handle and hold drill with both hands. CLAMP A side handle is supplied with your drill. To install the side handle, loosen the handle as shown in Figure 4 until the clamp portion fits past the chuck.
Page 9
3" Diameter Maximum If you need assistance in locating any accessory, please contact BUFFING WHEELS 3" Diameter Maximum DeWalt Industrial Tool Company, P.O. Box 158, 626 Hanover Pike, Hampstead, MD 21074 or call 1-800-4-DeWALT (1-800-433-9258). RUBBER BACKING PADS 4-5/8" Diameter Maximum Recommended accessories for your Drill are shown in this manual.
Page 10
158865/JAN95 5/20/02 3:47 PM Page 7 Full Warranty WALT heavy duty industrial tools are warranted for one year from date of purchase. We will repair, without charge, any defects due to faulty materials or workmanship. Arrangements have been made with the Industrial Tool Division of Black & Decker (U.S.) Inc.
Page 11
158865/JAN95 5/20/02 3:47 PM Page 8 Other D WALT Heavy Duty Industrial Tools Available From Your Local Dealer DW944K 9.6V Heavy Duty Versa-Clutch Cordless 3/8" Driver/Drill Kit with Keyless Chuck: High performance industrial Versa-Clutch cordless Driver/Drill has two variable speed ranges and reversing to perform well in a wide variety of metals and wood.
Page 12
158865/JAN95 5/20/02 3:47 PM Page 9 Other D WALT Heavy Duty Industrial Tools Available From Your Local Dealer DW100 Heavy Duty 3/8" VSR Drill: High performance industrial quality variable speed reversing drill is designed for long life in heavy-duty professional use. DW100 High speed (0-2500 RPM) and 4.0 amps enable the drill to perform well in a wide variety of metals, wood, masonry and...