Ironing Without Steam - Bosch B25L TDS25PRO1 Operating Instructions Manual

Controlling the pressure
Your steam station is equipped with a pressure
gauge (6) which shows the pressure it works at
every moment.
Dial of the gauge is divided into three areas
1. White area shows low pressure (during first
heating or loss of pressure during the ironing. In
this case, read Trouble Shooting section)
2 Green area is the one in which the station works
normally and pressure should be within it during
ironing
3 Red area shows high pressure and during normal
use should not be reached. In case your steam
station reaches it frequently, it will have to be
checked by a technical service centre
Ironing with steam (B)
1. Make sure that there is enough water in the
water tank
2. Turn the temperature selector to the steam
position, between «••» and «max».
3. Set the amount of steam to suit your needs,
using the variable steam control (5)
4. Press the steam release button to release steam
(17)
Important:
• The steam hose may get hot if you are ironing for
long periods.

Ironing without steam

1. Begin ironing but without pressing the steam
release button (17).
Vertical steam (C)
1. Set the temperature control to the «•••» or
«max» position.
2. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing the
iron in a vertical position and pressing the steam
release button (17).
Stain remover steam gun
Preparation:
Ensure that the appliance is not connected to the
mains. Remove connection plug for the iron (7) if
this is connected. Then lift the cover (31) and insert
the connection plug for the steam gun in the correct
position - with slot (29) to the left - Then follow the
same steps as for ironing, the indicator lights and
switches operate in exactly the same way.
Important:
When the gun is being used, while pushing Steam
release button (20), there might be some water
drops, but this is normal.
Attention
• Use the steam gun in intervals of no longer than
10 seconds at a time.
• Direct the first steam jets towards a cloth in order
to eliminate any possible water condensation
residue from the steam tube.
• Never direct the steam jet at garments that are
being worn by people or animals.
• Do not use the brush extension for delicate
fabrics such as silk or cashmere.
To refresh fabrics
Refreshing garments with the steam gun can
lessen creases and wrinkles, although this does not
substitute ironing with the iron.
For better results, hang the clothes wich you would
like to refresh on hangers.
• With diffuser (23) the sprayed steam enables
superficial fabric creases to be lessened.
• Comb brush (25) can be used for refreshing and
gently combing pile within fabric. Also, for general
purpose cleaning and refreshing of garments,
fabrics, upholstery and to remove fluffs
• Fabric cleanser (24) to be used with more delicate
garments such as velour, velvet and suede, for
refreshing and combing pile within material and
for removing pet hair/fur, dandruff, crumbs etc.
Fully insert the accesory into the concentrator (21).
Press the steam release button (20) for the steam
supply and direct the jet towards the fabric that you
would like to refresh. Maintain a minimum distance
of 10 cm to avoid getting the fabric too damp.
To remove fabric stains
The steam gun can help to remove washable, fresh
stains.
The concentrator (21) and brush extension (22)
supply a concentrated jet of steam that makes it
possible to remove certain types of fabric stains
• If the stain is not fresh, the garment should be
washed in a washing machine or hand-washed
according to the garment care label.
• For stubborn or non-washable stains, take the
garment to a specialist cleaning centre or dry
cleaners.
en
13