Removing the Lid Switch............................14 Removing the Top Cover .............................14 Removing the PCMCIA Bay ..........................15 Removing the System Fan ...........................15 Removing the Main Board............................16 Removing the Speaker Set ..........................17 Removing the Modem ............................17 Screws..................................18 Notice ...................................19 NEC Versa S800 Disassembly Manual Page 2...
Overview This document contains step-by-step disassembly instructions for the Versa S800 chassis. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Furthermore, the screws that are removed are shown next to the image of the parts themselves.
Inside the power supply are hazardous avviare il sistema senza aver prima messo a voltages that can cause serious personal injury. Always posto il coperchio return a defective power supply to your dealer. NEC Versa S800 Disassembly Manual Page 4...
Fig. 2: Removing the memory/mini PCI card slot cover 2. Pull apart the retaining clips in order to release the memory module. 3. Take the memory module out of its location and put it aside. NEC Versa S800 Disassembly Manual Page 5...
4. Pull apart the retaining clips in order to release the wireless mini PCI card as shown in Fig. 4: Fig. 4: Removing the wireless mini PCI card 5. Take the wireless mini PCI card out of the system and put it aside. Removing the Touchpad NEC Versa S800 Disassembly Manual Page 6...
Page 7
4. Disconnect the flat cable of the touchpad from the system as shown below in Fig. 6: . Fig. 6: Removing the touchpad cable 6. Take the touchpad assembly away from the system. NEC Versa S800 Disassembly Manual Page 7...
Fig. 6: and put it aside 4. To access the keyboard connector, carefully slide the keyboard from its original position. Note: Observe care when performing this operation. The keyboard is still connected to the system via a NEC Versa S800 Disassembly Manual Page 8...
1. Disconnect the front LED board cable for a better access to the hard disk drive. Fig. 10: Disconnecting the front LED board cable 2. Disconnect the hard disk drive cable by releasing the connector shown in Fig. 11: NEC Versa S800 Disassembly Manual Page 9...
Card), remove the touchpad assembly (see Removing the Touchpad), remove the keyboard (see Removing the Keyboard), then perform the following steps: 1. Turn the system upside down and remove the screws shown in Fig. 13: NEC Versa S800 Disassembly Manual Page 10...
Page 11
Note: Pay attention while extracting the antenna wires. Notice that they are firmly maintained in position by adhesive tape that will have to be removed as well. 5. Disconnect the LCD cable shown in Fig. 15: Fig. 15: Disconnecting the LCD cable NEC Versa S800 Disassembly Manual Page 11...
Fig. 17: Removing the inverter board screws 5. Remove, on both sides of the LCD assembly, the two screws marked in Fig. 18: M2x3 Fig. 18: Removing the LCD back cover screws NEC Versa S800 Disassembly Manual Page 12...
Page 13
M2x3 Fig. 20: Removing the LCD hinges 9. Flip the bare LCD and disconnect the LCD cable on its back (Fig. 21: ). Fig. 21: Removing the LCD cable from the bare LCD NEC Versa S800 Disassembly Manual Page 13...
Switch) then perform the following steps: 1. Remove the screws marked in Fig. 23: A=(M2x4) B=(M2x7) Fig. 23: Removing the top cover screws 2. Carefully lift the top cover from the system and put it aside. NEC Versa S800 Disassembly Manual Page 14...
To remove the system fan, first remove the top cover (see Removing the Top Cover), then perform the following steps: 1. Remove the two screws shown in Fig. 26: 2. Disconnect the connector marked in Fig. 26: NEC Versa S800 Disassembly Manual Page 15...
Fig. 27: Removing the USB plate and the RJ45/RJ11plate 2. Take the USB plate and the RJ45/RJ11plate out of the system and put them aside. 3. Disconnect the speaker set from the main board (Fig. 28: ) NEC Versa S800 Disassembly Manual Page 16...
2. Click the speakers out of their location and remove them from the case. Removing the Modem To remove the modem, first remove the main board (see Removing the Main Board), then perform the following steps: 1. Turn the main board face down. NEC Versa S800 Disassembly Manual Page 17...
5. Take the modem with the cable away from the main board and put them aside. Screws M2.5x4 mm M2.5x3 mm M2.5x3.5 mm M2.5x5 mm M2x2.5 mm black M2x3 mm M2x3 mm M2x4 mm M2x7 mm black NEC Versa S800 Disassembly Manual Page 18...
This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent from NEC Computers International BV. NEC COMPUTERS INTERNATIONAL BV SHALL NOT BE LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN;...