D-Link GO-RT-N300 Quick Install Manual
N300 wi-fi router
Hide thumbs
Also See for GO-RT-N300:
- User manual (83 pages) ,
- Quick installation manual (33 pages) ,
- User manual (84 pages)
Related Manuals for D-Link GO-RT-N300
Summary of Contents for D-Link GO-RT-N300
- Page 1 GO-RT-N300 N300 Wi-Fi Router Quick Install Guide...
-
Page 2: Package Contents
Package Contents N300 Wi-Fi Router Power Adapter Ethernet Cable Quick Install Guide If any of the above items are missing, please contact your reseller. Minimum Requirements Network Requirements: • An Ethernet-based broadband modem Web-based Configuration Requirements Computer with the following: •... -
Page 3: Hardware Overview
Hardware Overview A solid green light indicates a proper connection to the Power LED power supply. A solid green light indicates a connection to the Internet Internet LED port. The LED will blink during boot-up and during the WPS process. LAN Ports Connect Ethernet devices such as computers, switches, and (1-4) -
Page 4: Before You Start
• Advanced Users - If your ISP provided you with a modem/router combo, you will need to set it to “bridge” mode so the GO-RT-N300 router can work properly. Please contact your ISP or refer to the user manual for your modem/router device. - Page 5 If the Power LED does not light up, press the Power button on the back of the router. If connecting wirelessly, open your wireless utility on your computer and connect to the router. The Wi-Fi network (SSID) is GO-RT-N300 with no password. GO-RT-N300...
- Page 6 Configuration Open a web browser (e.g., Internet Explorer, Chrome, Firefox, or Safari) and enter the IP address of the router (192.168.0.1). Select your Internet type from the drop-down menu: DHCP (dynamic) is most commonly used with cable Internet, PPPoE (common with DSL), or Static. If you selected DSL (PPPoE), enter your PPPoE user name and password supplied by your ISP (Internet Service Provider).
- Page 7 If you selected Static IP, enter the IP information and DNS settings supplied by your ISP. At the bottom, enter the name you want for your wireless network (SSID) and then enter a Wi-Fi password (Key). Click Save and Connect.
- Page 8 Log in to the router. The user name is Admin and leave the password box empty. Click Login. The Status screen will appear. This will display the current status of your router including LAN IP settings, wireless (WLAN) settings, and Internet (WAN) settings.
- Page 9 Connect your Clients using WPS The easiest and most secure way to connect your wireless devices to the router is WPS (Wi-Fi Protected Setup). Most wireless devices such as wireless adapters, media players, Blu-ray DVD players, wireless printers, and cameras will have a WPS button (or a software utility with WPS) that you can press to connect to the router.
-
Page 10: Troubleshooting
2. Select the Wi-Fi Network name you assigned in the wizard and connect. You can also connect wireless devices to the GO-RT-N300 router using WPS: 1. Press the WPS button on the GO-RT-N300 for a minimum of three seconds. 2. Within one minute press the WPS button on your wireless device. -
Page 11: Gpl Code Statement
Where such specific license terms entitle you to the source code of such software, D-Link will provide upon written request via email and/or traditional paper mail the applicable GPL and LGPLsource code files via CD-ROM for a nominal cost to cover shipping and media charges as allowed under the GPL and LGPL. -
Page 12: Technical Support
Version 1.0 April 16, 2015 D-Link and the D-Link logo are trademarks or registered trademarks of D-Link. All other third-party marks mentioned herein may be trademarks of their respective owners. Maximum wireless signal rate derived from IEEE Standard 802.11g and 802.11n specifications. Actual data throughput will vary.