Loading Saved Data - Panasonic AJ-RC5 Operating Instructions Manual

Scene File Operations
Loading the saved data
Example: Loading data into scene No.3
1 Select the scene number from
which the data is to be loaded.
1 Press the S3 button.
REW
S1
STOP
PLAY
S3
The selected scene No. button now blinks.
<Notes>
≥ To change to another scene No., simply press
the button that corresponds to that scene No.
≥ To release the scene No. selection, press the
scene No. button which is now blinking again.
2 Load the setting data.
1 Press the LOAD button within 10 seconds
of performing the operation in 1-1.
REW FF
S1 S2
STOP
PLAY
S3 S4
While the data is being loaded, the selected
scene No. button stops blinking and comes on.
START/STOP
FF
S2
SAVE
REC CHK
LOAD
S4
START/STOP
SAVE
REC CHK
LOAD
REW
S1
STOP
S3
The load operation is completed when both the
scene No. button used to load the data stays on
and the LOAD button comes on.
<Note>
After the data has been loaded, the operation
mode (scene mode) prescribed by the loaded
scene data is established, and the KNEE
SLOPE, KNEE POINT, DETAIL, GAMMA and
M.PED VR control operations differ slightly from
their regular operations. For further details,
refer to the section entitled "Operation mode
established by scene file data <scene mode>."
E-10
START/STOP
FF
S2
SAVE
PLAY
REC CHK
LOAD
S4