Haier HWD1500 User Manual page 11

As shown in figure1, remove all
the packing materials(including
the foam base).
Upon opening of the package,
water drops may be seen on the
plastic bag and the porthole. This
is a normal phenomenon resulting
from water tests in the factory.
Water tests are conducted to check
for leakage.
Removethree transportationbolts as shown in
figure 2A. The bolts protect the appliance
from shockduring transportation.Thestepsbelow
should be followed before using theappliance:
1. Removethe back plate of the washing
machine.To removethis you mustremove
three screwsholding the panel.
2. Now you could removethe transportation bolts.
While removing the three bolts from the rear
of thewashing machine, removethe rubber
hoseswhich are behind the transportation
bolts inside the unit at the sametime. Remove
themetalbracket and save in a safe place for
later use.
3. Reinstall t he back plate.
4. Fill the holes left by the boltswith plastic plugs.
(Attention:The bolts and rubber hoseshould
be kept in a safe placefor later use.)(Fig. 2B)
Back Plate
Fig. 2
Fig. 1
Transportation Bolt
Metal
bracket
Screws
Levelingthe washing machine:Thereare
adjustable feet under the bottom of the
washing machine.Beforeuse, thewashing
machine shouldbe adjusted, as shown in
figure 3, so that it is level.
Levelinglegs can be adjusted by turning them
counterclockwise to raise your washer or
clockwiseto lower your washer.
Fig. 3
lg