INSTALL FILTERS
11
• Remove protective film covering the filters.
• Insert the filter into the "C" clips mounted to the top of
the vertical front panel.
• Tap the filter against one side to align with outside
opening.
• Pull the filter down into the lower slots at the bottom
of the filter support.
"C" Clip
Filters
Before you call for service...
Troubleshooting Tips
Save time and money! Review the chart below first and you
may not need to call for service.
Problem
Fan does not operate
when the switch is on
Fan fails to circulate air
or moves air slower than
normal
18
Installation Instructions
Filter
Support
Possible Causes
A fuse may be blown or a
circuit breaker tripped.
The blower connector is loose
or not plugged into its mating
connector.
Excessively soiled filters.
• To remove the filters, grasp the handle, push the filter
up, and pull forward.
FINALIZE INSTALLATION
12
• Refer to the operating instructions to test all controls.
What To Do
• Replace fuse or reset circuit breaker.
• Disconnect power to the unit. Remove the filters
and look up at the blower. If the blower connector
plug is loose or you see the connector dangling,
the installer failed to plug it in securely. Although it
is a blind connection, it is easy to plug in. See the
Installation Instructions in this manual for the plug
location and how to plug the connector in.
• Remove the filters, clean if necessary and replace
them. If cleaning and replacing the filters does not
correct the problem, call for service.
• Sufficient makeup (replacement) air is required for
local building codes, which may require or strongly advise
the use of makeup air. Visit GEAppliances.com for available
makeup air solutions.
49-80520-7