Adjusting The Maximum Ground Speed; Adjusting The Tracking - Toro 30695 Operator's Manual

9. Repeat steps 6 through
machine.
10. Tighten the jam nuts at the ball joints
11. Move the throttle lever to the Slow position and stop
the engine.
12. Remove the jumper wire from the wire harness
connector and plug the connector into the seat switch.
WARNING
Electrical system will not perform proper
safety shut off with jumper wire installed.
• Remove jumper wire from wire harness
connector and plug connector into seat
switch when adjustment is completed.
• Never operate this unit with jumper
installed and seat switch bypassed.
13. Lower the seat into position.
14. Remove the jack stands.
Adjusting the Maximum
Ground Speed
1. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Remove the bolts securing the front panel and remove
the panel (Figure 50).
2
1
1. Bolts
2. Control panel
4. Loosen the jam nut on the stop bolt for one of the
control levers (Figure
8 for the other side of the
(Figure
G020875
Figure 50
51).
47).
1. Stop bolt
2. Control lever
5. Thread the stop bolt all the way in (away from the
control lever).
6. Push the control lever all the way forward until it stops
and hold it there.
7. Thread the stop bolt out (toward the control lever)
until there is a gap of 1.5 mm (0.060 inch) between the
head of the stop bolt and the control lever.
8. Tighten the jam nut to secure the stop bolt in place.
9. Repeat steps
10. Install the front panel.
Note: If you wish to reduce the maximum machine speed,
set the speed for both control levers as directed above, then
back each stop bolt out an equal amount toward the control
lever until you reach the maximum speed you desire (you will
likely have to test your adjustment several times). Ensure that
the machine drives straight and does not turn when both
control levers are pushed all the way forward. If the machine
turns, you do not have the stop bolts evenly set and will need
to adjust them further.

Adjusting the Tracking

1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Loosen the bolts securing the control levers
45
Figure 51
3. Jam nut
4. 1.5 mm (0.060 inch)
4 through 8 for the other control lever.
(Figure 52)