Disconnecting the Alternator
Wiring
1. At the alternator, slide the boot off the terminal and
stud at the back of the alternator
Figure 116
1. Charge wire
2. Boot
2. Remove the nut and washer that secures the terminal
of the charge wire to the stud of the alternator, and
remove the terminal.
3. Remove the 4-socket connector for the voltage-sense
wire from the 4-pin connector on top of the alternator
(Figure
116).
Disconnecting the
Computer-module Connectors
1. Remove the 4 hex-flanged head bolts (6 x 20 mm) that
secure the lower-console panel to the console, and
remove the panel
(Figure
(Figure
116).
3. 4-socket connector
(voltage-sense wire)
117).
1. Lower-console panel
2. Disconnect the 50-socket connector (CPU 1) from the
back of the computer module
1. Forward
2. 50-socket connector (CPU
1)
3. Disconnect the 38-socket connector (CPU-2) from the
back of the computer module
Connecting the
Computer-module Connectors
1. Connect the 38-socket connector (CPU-2) to the back
of the computer module
2. Connect the 50-socket connector (CPU 1) to the back
of the computer module
74
Figure 117
2. Hex-flanged head bolts (6
x 20 mm)
(Figure
118).
Figure 118
3. Computer module
4. 38-socket connector
(CPU-2)
(Figure
118).
(Figure
118).
(Figure
118).