16. Slide a gasket over the detent assembly and then
position the detent cover over the detent (Fig. 0058).
17. Install 2 Allen cap screws to secure the detent cover
to the valve body (Fig. 0059).
Toro Wheeled CUL Service Manual
IMG-0212a
Fig. 0058
IMG-0214a
Fig. 0059
ALL UNITS/GENERAL
100-4163 Hydraulic Cylinder Rebuild
1. Clean away all dirt and other foreign substance from
openings, particularly at the head of the hydraulic
cylinder.
2. Clamp the tilt cylinder barrel in a vise (Fig. 0060).
Note: If excessive wear due to side-loads or binding
is a possibility, mark or note the piston and
head relationship to the rod and barrel. This
condition will usually show up as a highly
polished surface on the piston and head 90°
to the pin rotation axis (Fig. 0061).
IMG-0372a
Fig. 0060
IMG-0373a
Fig. 0061
3/1-17