Toro 30411 Groundsmaster 4100-D Operator's Manual page 35

if damaged or worn. Bearings should operate
smoothly with no detrimental characteristics such
as high heat, noise, looseness or indications of
corrosion (rust).
Due to the operating conditions these bearing/seal
packages are subject to (i.e. sand, turf chemicals,
water, impacts, etc.) they are considered normal
wear items. Bearings that fail due to causes other
than defects in materials or workmanship are
typically not covered under warranty.
Note: Bearing life can be negatively affected
by improper wash down procedures. Do not
wash down the unit when it is still hot and avoid
directing high-pressure or high volume spray at
the bearings.
The grease fitting locations and quantities are:
Traction Unit
• Brake shaft pivot bearings (5) (Figure 34)
• Traction pedal pivot bushing (1) (Figure 35)
• Front and rear axle pivot bushings (2)
(Figure 36)
• Steering cylinder ball joints (2) (Figure 37)
• Tie rod ball joints (2) (Figure 37)
• King pin bushings (2) (Figure 37).
The top fitting on the king pin should only
be lubricated annually (2 pumps).
Figure 34
Figure 35
Figure 36
Figure 37
Center Cutting Unit
• Upper link pivot (4) (Figure 38)
35