Oven Light - Electrolux E36DF76GPS Use & Care Manual

32
Care & Cleaning
to ReMove and RePlace oven dooR
1. Open the door to the fully opened position.
2. Pull up the lock located on each hinge support toward front of range. You may have to
3. Grasp the door by the sides, pull the bottom of the door up and toward you to
4. Proceed in reverse to re-install the door. Make sure the hinge supports are fully
Lock in normal position

oven liGHt

An interior oven light will turn automatically when the oven door is opened. The oven light
may be turned on when the door is closed by using the oven light switch located on the
control panel.
The lamp is covered with a glass shield. The glass shield can be remove to be cleaned
manually or to change oven light.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
lift backside of glass
to replace the light bulb:
shield and remove it.
CAUTION: BE SURE THE OVEN IS COOL.
Halogen
1. Turn the power off at the main source.
light bulb
2. Wear a leather-faced glove for protection against possible broken glass.
3. To remove the glass shield, pull the back side of the shield toward the inside of the
4. The glass shield should come out easily by pushing a little toward front of the wall
5. Replace halogen light appliance bulb taking care to not touch the bulb. If you touch
6. To replace glass shield, proceed in reverse.
apply a little upward pressure on the lock to pull it up.
disengage the hinge supports.
Keep pulling the bottom of the door toward you while rotating the top of the door
toward the appliance to completely disengage the hinge levers.
engaged before unlocking the hinge levers.
Removal of the oven door
Lock engaged
for door removal
oven in a manner to lift it up from the oven side.
oven.
the halogen bulb with finger that can damage it and also burn it.
HINGE SLOT - Door re-
moved from the appliance