Section 700 - Operation
To check a programmed FF key (Display Phone Only):
1. Lift the handset or press the ON/OFF key.
2. Press the CONF key.
3. Press the FF key to be checked.
4. Replace the handset or press the ON/OFF key.
Hardware Requirements
•
N/A
Related Programming
•
FF1-2: Dial Plan
•
FF3: Extension Numbers
•
FF4: FF Key Assignment
Considerations
•
If a new code is programmed into a key, the previously programmed code is erased.
•
FF keys assigned as CO lines must be cleared using system programming before new FF
assignments can be made.
•
The System can be programmed so that MCO 1 Trunk Access calls automatically use Automatic
Route Selection (ARS).
•
The ANSWER key functions as listed in the table below.
Status
Idle
Off-Hook
Note: When the extension has 1 non-appearing CO on hold and 1 non-appearing CO at talk,
ANSWER key operation is ignored and you can't put the 2nd non-appearing CO on hold.
•
The RELEASE key functions as listed in the table below.
Status
Idle
Monitor ON
(speaker) or Headset
Mode
576-36-700
Action
Condition
No incoming ring
Incoming ring
Off-hook signaling
No off-hook signaling
Condition
--
Several held calls
No held calls
DBS 576 (USA) issued October 2000
Chapter 5. Key Telephone Features
Result
Intercom dial tone
C displays
Programmed data displays
Operation when ANSWER key is pressed
Ignore.
Monitor ON (speaker) - Auto Answer for incom-
ing ring.
Answer for off-hook signaling. Current conver-
sation will be put on hold automatically.
Ignore.
Operation when RELEASE key is pressed
Ignore.
Latest held call will be transferred; phone returns
to idle status (Monitor OFF).
Current call (talk) will be released; phone returns
to idle status (Monitor OFF).
5-51