Keyboard Commands, Pelco Protocol - Bosch MIC612 Operation Manual

MIC612 Thermal Camera
Notice!
The convention used for control key commands in this manual is ON, OFF, SET, and SHOT.
Refer to your keyboard manual for the key naming conventions.
–
–
For example, the keyboard command to make the camera pan 360º continuously is:
ON-1-ENTER (Press the ON key, then press the number 1 key, and then press ENTER.)
Refer to Keyboard Commands (Bosch Protocol) By Number for a complete list of commands.
7.3.4

Keyboard Commands, Pelco Protocol

Pelco control commands are composed of a sequence of two (2) keyboard inputs with the
following convention: 1) a Command Number and 2) a Function key input.
The camera uses the PRESET command key to save and recall presets (pre-positions) 1
through 99.
Notice!
To save a preset, enter the desired number and hold the PRESET key for approximately two
(2) seconds. To recall a preset, enter the desired preset number (or command) and
momentarily press and release the PRESET key.
Keyboard Command User Action
0-Pattern
1-Pattern
2-Pattern
3-Pattern
4-Pattern
1 – Aux On / Aux
Off
2 – Aux On / Aux
Off
Bosch Security Systems
Command numbers range from 1 to 999. See Keyboard Commands (Bosch Protocol) By
Number, page 83 for a complete list of keyboard commands for Bosch protocol.
The Enter key can also be labeled with the ∞ symbol.
Press
Press and hold Initiates recording based upon current Recording
Press
Press and hold Initiate Recording A. Press ACK to end recording.
Press
Press and hold Initiate Recording B. Press ACK to end recording.
Press
Press
Press
Press
Description
Initiates recording continuous playback based upon
current Recording setting (A or B) in the Setup
Menu.
setting (A or B) in the Setup Menu. Press ACK to
end recording.
Initiate Recording A continuous playback.
Initiate Recording B continuous playback.
Initiate the standard preset tour (Tour 1).
Initiate the custom preset tour (Tour 2).
Activates / deactivates alarm output 1.
This command is supported with Non-IR models
only if an optional 8-input alarm card is installed in
the PSU powering the camera.
Activates / deactivates alarm output 2.
This command is supported with Non-IR models
only if an optional 8-input alarm card is installed in
the PSU powering the camera.
Operation Manual
Getting Started | en 33
2016.03 | 2.1 | F.01U.249.416