Disabling The Vrm Service - Bosch 1200 Series Quick Installation Manual

8 en | Disabling the VRM Service
5.
6.
7.
4

Disabling the VRM Service

The system always comes with the VRM application preinstalled but if these are intended to
be used only as a disk array the VRM Service can be disabled:
1.
- | V1 | 2011.02
Click Properties, select Internet Protocol Version 4 (TCP/IPv4), then click Properties.
This dialog box allows you to set the IP address configuration according to the
requirements of your network.
Reboot the system.
Log on to the storage system, then start the Bosch VRM Appliance initial configuration
window. The top level view of the Bosch VRM Appliance initial configuration window
displays an overview of the system's configuration and settings.
If the Bosch VRM Appliance initial configuration window is not displayed, click Start >
Run > oobe.
Quick Installation Guide
1200/1400 Series as standard iSCSI disk array
Bosch Sicherheitssysteme GmbH