Panasonic NP-B6M1FIGB Service Manual page 13

4.2. Test mode list
Phase Description
TEST MODE BEGINNING:
1)
The door should be closed when the test mode
operates.
TEST MODE BEGINNING
2)
Close the door. After some seconds the machine
starts to fill the water. The cycle could start with
drain.
DETERGENT DISPENSER OPENING
3)
After the pressure switch level has been
reached, the machine ends the filling, the heat-
ing element is activated and the dispenser unit is
being supplied.
HEATING:
4)
The machine starts the heating till reaching 45. Upper basket 30sec
HEATING
5)
The machine starts the heating till reaching 50.
WAITING THE OPERATOR INTERVENTION
6)
(it lasts max 30)
Once the temperature is reached, the machine
continues to wash.
regeneration coil works ( it lasts max 30 min-
utes). To proceed the mode, you needs to lift the
antiflood safety device (polystyrene) or to press
the program selection button..
FINAL DRAIN
7)
Once the antiflood safety device is activated ,
the machine drains.
DOOR OPENING/ WAITING THE OPERATOR
8)
INTERVENTION/TEST MODE END
At the end of the drain phase, the generation
electric valve is activated to open the door (max
3'). Once the machine is switched off, the test
mode ends. (see point 9). Once the program
selection button is pressed, the automatic test
proceeds (it lasts max 3+15 minutes)
AUTOMATIC TEST MODE FOR THE FINAL
9)
LOAD
Once the program button is pressed, the water is
filled in order to start the following automatic test
mode till reaching the pressure switch full condi-
tion (+ 2")
TEST MODE END
10)
Once the final load is done, the display shows as
described on the right. Switch the machine off
and open the door to check the detergent dis-
penser opening. Switch the machine on and ver-
ify that the programs/options warning lights
work.
Alternate valve postion
Upper spray arm
(upper washing, if it is
foreseen)
Upper basket
Lower basket 30sec
Lower basket
During this phase , the
Lower basket
(Upper basket)
(Upper basket)
(Upper basket)
(Upper basket)
13
Warning lights