Page 1
This manual is designed to be used with your Digital DSS Console and a Panasonic PBX. The Digital DSS Console can be used with the following Panasonic Digital Proprietary Telephones (DPTs): KX-DT333, KX-DT343, and KX-DT346. The Digital DSS Console must be connected directly to the main unit.
Location of Controls DSS Buttons with Busy Lamp Field (BLF): To access an extension, simply press a DSS button. These buttons also can be assigned for the One-touch Dialling and reassigned to other features. The BLF indicates the current status of the corresponding extension.
Page 3
1, repeat this step. Attaching a DPT 1. Fit the protrusions on the 2. Attach the plate with the 4 KX-DT390 and a DPT into the screws (included). 4 holes on the plate (included).
Wall Mounting CAUTION: Do not mount this unit on a wall while attached to a DPT. Doing so may damage the wall mounting adaptor or, may cause the unit to fall, possibly resulting personal injury. 1. Remove the wall mounting adaptor from the unit as shown.
Page 5
Important Information When using a KX-DT390 Digital DSS Console, keep the following conditions in mind. • If you are having problems making calls, unplug the extension line and connect a known working Digital DSS Console. If the known working DSS Console operates properly, have the defective DSS Console repaired by an authorised Panasonic factory service centre.
Page 6
ELECTRIC SHOCK. CONFIRM THAT SMOKE HAS STOPPED AND CONTACT AN AUTHORISED SERVICE CENTRE. 1731 This product is intended to be connected to a Panasonic PBX only. Panasonic Communications Company (U.K.) Ltd. declares that this equipment is in compliance with the essential requirements and other relevant provisions of Radio &...
Important Information Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the...
WALL MOUNTING TEMPLATE 1. Drive the screws into the wall as indicated. Note: • If the KX-DT390 is mounted beside a DPT, leave 157 mm of space between the 2 screws for the DPT and the 2 screws for the KX-DT390, as indicated above.