EAM20181
INSTRUMENT AND CONTROL
FUNCTIONS
EAM30400
WARNING LIGHTS
1. Engine trouble warning light "
2. Fuel level warning light " "
Engine trouble warning light "
This warning light comes on or flashes if a prob-
lem is detected in the electrical circuit monitoring
the engine. If this occurs, have a Yamaha dealer
check the vehicle.
The electrical circuit of the warning light can be
checked by pushing the start switch. The warn-
ing light should come on for a few seconds, and
then go off.
If the warning light does not come on initially
when the start switch is pushed, or if the warning
light remains on, have a Yamaha dealer check
the electrical circuit.
Fuel level warning light " "
This warning light comes on when the fuel level
drops below approximately 2.0 L (0.53 US gal,
0.44 Imp.gal). When this occurs, refuel as soon
as possible.
The electrical circuit of the warning light can be
checked by pushing the start switch. The warn-
ing light should come on for a few seconds, and
then go off.
If the warning light does not come on initially
when the start switch is pushed, or if the warning
light remains on, have a Yamaha dealer check
the electrical circuit.
EAM30182
ENGINE STOP SWITCH
The engine stop switch "1" is located on the left
handlebar. Continue pushing the engine stop
switch till the engine comes to a stop.
INSTRUMENT AND CONTROL FUNCTIONS
1
2
"
"
1-20
EAM30183
START SWITCH
The start switch "1" is located on the right han-
dlebar. Push this switch to crank the engine with
the starter.
EAM30185
SHIFT PEDAL
The shift pedal "1" has adopted a method of 1
down & 4 ups (press-down & kick-ups).
Press it down for N (neutral) to 1st, and kick it up
for 2nd to 5th.
5 5
4 4
3 3
2 2 2
N N
1 1 1
Recommended shift points
The recommended shift points during accelera-
tion and deceleration are shown in the table be-
low.
1
1
1 1 1