Bestway Lay-Z-Spa How To Maintain

The Comfortable, Affordable, Go-Anywhere Spa!
1
The Lay-Z-Spa™ should not
be setup or left out in
temperatures lower than
4˚C (40˚F).
Hibernate Function:
11
After 72 hours of operation (except timer
function), the pump will hibernate and
"END" will be display on the LED. When
the pump is hibernating both the rapid
heating and water filtration functions are
disabled. To re-active the pump simply
press any button on the control panel.
10
All Spas require the use
of chemicals in order to
keep the water clear and
safe.
™
™
RESET
TEST
2
The PRCD must be tested
before each use.
12
IMPORTANT NOTICE:
13
This unit will auto lockout after
5 minutes of inactivity.
We recommend you take a shower
To simply place a finger
over function button cosmetic products, lotions, and other
for 3 seconds.
9
If the pump not heating properly,
please press the thermal cut-out
manual "Reset" button on
the pump.
Congratulations on the purchase of your new Lay-Z-Spa™. Before
operating the Lay-Z-Spa™ be sure to follow these 14 steps.
Damage resulting from misuse is not covered by the
manufacturer's warranty.
MAX
MIN
Water
3
Level
Fill the water level between 4
maximum and minimum
printed on the SPA wall.
14
before using your Lay-Z-Spa, as
residues on the skin can quickly
degrade water quality.
8
Change the Filter Cartridges
regularly
Remove Stopper Caps
Ensure water is circulating between
the Spa and the Pump and that the
Stopper Caps have been
removed.
5
Be sure to set your
desired temperature.
6
Check and ensure the Spa and
adapters are not leaking.
7
Clean and maintain the Filter
Cartridge regularly.
1
303021213613