TRENDnet User's Guide
Setting up THA‐103AC
There are 3 ways to setup the THA‐103AC switch to connect with your existing wireless
network; WPS, using a mobile app, or going through device's web configuration page.
When using a mobile app to setup the device manually, the mobile device needs to
support either wireless N or wireless AC connection. If your mobile device does not
support wireless AC connection, you will only see THA‐103_24G_1234 SSID instead of
both SSIDs.
WPS Setup
1. Plug the device near a router and wait for the device to boot up.
2. Press the WPS button on the router and press the WPS button on THA‐103AC
to initiate the connection
3. Once connected successfully, unplug THA‐103AC and move to the final
destination.
Note: If you use WPS to connect to 2.4Ghz network, both bands on THA‐103AC will use
router's 2.4Ghz wireless encryption. If you use WPS to connect to the 5Ghz on the
router, both bands on THA‐103AC will use router's 5Ghz wireless encryption. You can
manually change them by going into the configuration page of THA‐103AC. And also
please make sure the switch is within the range of your wireless network.
Web Browser Setup
Please refer to Browser Management section for browser installation and for more app
features, please refer to Managing the App section.
© Copyright 2015 TRENDnet. All Rights Reserved.
iOS Setup
A smart phone is required to proceed with this setup.
1.
Download TRENDnet Smart Home app from Google Play or Apple Store.
2.
Plug the THA‐103AC to a power outlet and power on the device.
3.
Connect your mobile phone to THA‐103AC via wireless; you should be able to
see a Network Name similar to THA‐103AC_24G_1234 for 2.4 GHz wireless
band or THA‐103AC_5G_1234 for 5 GHz wireless band under the available
wireless network list. Connect to one of it depending on your mobile phone's
support (default wireless key is password). Once connected, open the
TRENDnet Smart Home app.
THA‐103AC
4