HP Compaq Presario CQ62 Maintenance And Service Manual page 82

Remove the following cables from the system board:
●
Power connector cable (see
●
USB board cable (see
1. Turn the computer upright with the right side toward you.
2. Remove the four Phillips PM2.5×4.0 (1) screws that secure the system board to the computer.
3. Grasp the right edge (2) of the system board.
4. Lift the system board (3), and pull it away from the base enclosure at an angle.
Reverse this procedure to install the system board.
74 Chapter 4 Removal and replacement procedures
Power connector on page
USB board on page 64)
66)