Power Connector - HP Compaq Presario CQ62 Maintenance And Service Manual

Power connector

Description
Power connector (includes cable)
Before removing the power connector cable:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn on
the computer, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first disconnecting the power cord from the AC
outlet and then disconnecting the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
Remove the power connector cable:
1. Turn the computer upright with the right side toward you.
2. Disconnect the power connector cable (1) from the system board.
3. Lift the power connector (2) from the clips built into the base enclosure.
Reverse this procedure to install the power connector.
66 Chapter 4 Removal and replacement procedures
Battery on page 41).
Hard drive on page 42)
Optical drive on page
Keyboard on page 52)
Top cover on page 55)
45)
Spare part number
609154-001