Do not operate Jumpstarter in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes. Keep bystanders, children, and visitors away while operating the Jumpstarter. Distractions can cause you to lose control. SKU 91045 Page 2...
13. Use safety equipment. Always wear eye protection. A dust mask, non-skid safety shoes, hard hat, or hearing protection must be used for all appropriate conditions. SKU 91045 Page 3...
Page 4
(for a negative grounded system). Keep clear of fan blades, belts, pulleys, and other moving parts of the engine that may cause injury, or damage to the Jumpstarter. SKU 91045 Page 4...
Do not expose the battery to rain or wet conditions. To avoid damage of cable and plug, never pull the cable to disconnect the Jumpstarter. Do not use the Jumpstarter if the cables or plugs are damaged. SKU 91045 Page 5...
OSHA requirements and complies with the applicable standards of Underwriters Laboratories, Inc., the Canadian Standard Association, and the National Electrical Code. (See illustration below.) Double insulated tools may be used in either of the 120 volt outlets shown in the following illustrations. SKU 91045 Page 6...
0 – 2.0 2.1 – 3.4 3.5 – 5.0 5.1 – 7.0 7.1 – 12.0 12.1 – 16.0 16.1 – 20.0 * Based on limiting the line voltage drop to five volts at 150% of the rated amperes. SKU 91045 Page 7...
Page 8
Assembly Drawing and Parts List at the end of this manual. Jumpstarter Unit Charging Line Cord (5) Accessory Power Cord (20) If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible. SKU 91045 Page 8...
Unplug the Charging Line Cord (5) from the electrical outlet or extension cord and the Jumpstarter. Store the Charging Line Cord in the Jumpstarter box. Press the Status Test Button (15) to verify that the internal Battery (6) is fully charged. SKU 91045 Page 9 REV 09/04...
Page 10
Optionally, use the supplied Accessory Power Cord (20) to power electronic devices that use 12 VDC as its power source. (20) (Example: Lap Top Computers, electronic keyboards, electric shavers) (See photo at right.) When finished, remove the appliance adapter cord and store the Jumpstarter. SKU 91045 Page 10...
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 91045 Page 11...
Status Test Button Panel sticker Sticker Recharge indicator label Screws (not shown) Accessory Power Cord NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as re- placement parts. ASSEMBLY DRAWING SKU 91045 Page 12...