Power Connector Cable - HP 350 G2 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the Battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d. Keyboard (see
e. Top cover (see
f. Speakers (see
g. System board (see
Remove the power connector cable:
1. Release the display panel cable (1) from the routing channel built into the base enclosure.
2. Release the power connector cable (2) from the routing channel built into the base enclosure.
3. Release the power connector (3) from the molding built into the base enclosure.
4. Remove the power connector cable.
Battery on page 30), and then remove the following components:
Service cover on page
Hard drive on page 32)
Optical drive on page
Keyboard on page 39)
Top cover on page 42)
Speakers on page 50)
System board on page
31)
37)
53)
Component replacement procedures
Spare part number
758054-001
63