Display Subcomponents (Bezel, Webcam, Panel) - HP Compaq CQ58 Maintenance And Service Manual

Display subcomponents (bezel, webcam, panel)

This section describes removing display subcomponents that do not require that you remove the entire
display assembly from the computer. You can remove the display bezel, webcam/microphone module, and
display panel while the display assembly is still attached to the computer.
To remove the remaining display subcomponents, including the hinge covers, hinges, cable, antennas, and
enclosure, you must remove the entire display assembly from the computer. See
on page 75
Description
Display bezel for use on HP models (includes Mylar screw covers)
Display bezel for use on Compaq models (includes Mylar screw covers)
Raw display panel, 39.6-cm (15.6-inch), HD, LED, BrightView
HP webcam/microphone module, HD
HP VGA webcam/microphone module
Before removing the display bezel, webcam/microphone module, and display panel while the display
assembly is still attached to the computer, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
To remove the display bezel, webcam/microphone module, and display panel while the display assembly is
still attached to the computer:
1. Position the computer right-side up with the front toward you, and then open it.
2. Remove the two Mylar screw covers (1) and the two Phillips PM2.5×4.0 screws (2) that secure the
display bezel to the display assembly. The Mylar screw covers are included with the display bezel spare
part kit.
3. Flex the inside edges of the top edge, the left and right sides, and the bottom edge of the display bezel
until the bezel disengages from the display enclosure.
40 Chapter 4 Removal and replacement procedures
for more information about removing the display assembly in its entirety.
Battery on page 39).
Display assembly
Spare part number
689675-001
689676-001
689690-001
703461-001
685112-001
ENWW