HP 425 Installation Manual page 12

Figure 10 T-rail holder
1 2
5
6
7
(1) T-rail clip
(4) T-rail holder
(7) M3 × 8 screw
To mount the AP to a ceiling T-rail:
1. Loosen the two M3 × 8 screws on each clip holder. Do not remove the screws.
2. Adjust the T-rail clips to make the T-rail holder wider than the T-rail. See callout 1 in
lock the T-rail with the T-rail holder according to the arrow indicated in callout 2 in
Figure 11 Attaching the T-rail holder to the T-rail
1
3. Tighten the four M3 × 8 screws on the two clip holders.
4. Verify that the T-rail holder is attached to the T-rail.
5. Hook the mounting clip (see callout 3 in
hook (see callout 2 in
6. Insert the two M4 × 5 screws (see callout 1 in
holes on the wall-mounting bracket according to the dashed line shown in
screws to the T-rail holder.
7. Verify that the wall-mounting bracket is attached to the T-rail.
8. Connect the AP to the network by using an Ethernet cable.
9. Install the AP to the wall-mounting bracket. For more information, see
3
8
(2) M4 screw nut
(5) M3 screw nut
(8) Mounting hook
2
Figure
Figure 12) of the T-rail holder.
9
4
(3) Clip holder
(6) M4 × 5 screw
12) of the wall-mounting bracket to the mounting
Figure 12) through the two 5 mm (0.20 in) diameter
Figure 11. Then
Figure
Figure 12. Attach the
"Mounting the AP on a
11.
wall."