Behringer ct100 cable tester: user guide (6 pages)
Summary of Contents for Behringer CT100
Page 1
Users Manual Version 1.0 April 2001 www.behringer.com...
Page 2
2. CABLE TESTER MODE Move the ON switch to the CABLE TESTER position. Insert one end of your cable into any OUT jack of the CT100. Connect the other end of the cable to any IN jack. The LEDs will indicate which input pins are connected to each output pin.
Page 3
CABLE TESTER MODE. To test a cable for short circuits, connect one end of the cable to the appropriate OUT jack of the CT100. The display works as in CABLE TESTER MODE (see chapter 2). However, it now indicates connections between out pins. If no LEDs light, the cable is free of short circuits.
Page 4
CABLE TESTER CT100 TEST TONE MODE may be used to check signal flow and to facilitate level adjustments. It routes a test tone to the + pin (pin 2/tip) of all OUT jacks. Use the TEST TONE LEVEL switch to choose between +4 dBu, -10 dBV, or -50 dBV mic level.
7. WARRANTY For our current warranty terms, please refer to our website at http://www.behringer.com, or send us a request via e-mail at support@behringer.de, fax at +49 2154 920 665, or telephone at +49 2154 920 666. 8. MULTILINGUAL DOCUMENTATION The following versions of this users manual can...