Oil And Fuel; Oil Requirements; Oiling System - BRP 2011 WRL User Manual

Using Your E-TEC Outboard

OIL REQUIREMENTS

Evinrude/Johnson Brand Oils
Evinrude/Johnson outboard oils are formulat-
ed to give best engine performance while
controlling piston and combustion chamber
deposits, providing superior lubrication, and
ensuring maximum spark plug life.
The following outboard oils are recommend-
ed for use in your Evinrude E-TEC outboard:
• Evinrude/Johnson XD100;
• Evinrude/Johnson XD50; or
• Evinrude/Johnson XD30.
Evinrude/Johnson XD100 Oil
Evinrude/Johnson XD100 oil is preferred
for your Evinrude E-TEC outboard. This
synthetic formula oil provides uncompro-
mised lubrication and superior performance,
even in extreme conditions—especially in
cold temperatures down to 0°F (-17°C).
If requested, an authorized dealer can pro-
gram your Evinrude E-TEC outboard EMM
for the exclusive use of Evinrude/Johnson
XD100. Only an authorized Evinrude deal-
er can program your outboard for this op-
tional benefit.
Oil consumption is reduced if the outboard is
programmed for exclusive use of Evinrude/
Johnson XD100 as compared to using a con-
ventional oil.
IMPORTANT: If your EMM has been pro-
grammed for Evinrude/Johnson XD100,
DO NOT use any other oil unless in an emer-
gency. If Evinrude/Johnson XD100 is tempo-
rarily unavailable, a one-time-only use of an
oil that meets NMMA TC-W3 certification
standards is allowed. If you discontinue using
Evinrude/Johnson XD100, you MUST first re-
turn to your Dealer to have the EMM repro-
grammed back to the original factory setting.
Other Oils
If Evinrude/Johnson brand oils are not avail-
able, you must use an oil that meets NMMA
TC-W3 certification standards.
IMPORTANT: Failure to follow oil specifica-
tions could void the engine warranty if a lubri-
cation-related failure occurs.
16

OIL AND FUEL

OILING SYSTEM

If the "LOW OIL" warning light illuminates,
you have approximately five hours of normal
operation before running out of oil. Refill the
oil tank at next convenient opportunity.
Always "top off" your oil tank prior to pro-
longed usage or long trips.
New outboards are programmed to use addi-
tional oil during the first two hours of opera-
tion above 2000 RPM.
Refer to Engine Overheating on page 29.
NOTICE
under
XD100 oil must be used.
Always keep an extra supply of outboard oil in
the boat. Refer to Oil Requirements on page
16.
If you run the oil tank empty, you MUST refill
the oil tank and prime the oil system before
using the engine. Refer to Filling the Oil
Tank on page 17 and Priming the Oil Sys-
tem on page 16.
Priming the Oil System
The oiling system MUST be primed before
using the outboard if:
• The outboard is new (Oil system MUST be
primed);
• You run completely out of oil; or
• The outboard is laid down for transportation
or storage.
Prime the oiling system by performing Long-
Term Storage (Winterization) on page 40.
When operating in conditions
32°F (0°C), Evinrude/Johnson