Battery - BRP Evinrude E15D Operator's Manual

Product Information
Install propeller nut and tighten to a torque of
70-80 ft. lbs. (95-109 N·m).
Install keeper on propeller nut, align keeper
slots and cotter pin hole.
Install new cotter pin and bend ends to se-
cure.
Remove block of wood. Make sure engine is
in NEUTRAL; give propeller a spin. It must
turn freely.
Repair
If your propeller hits a solid object, the impact
is partially absorbed by the rubber bushing in
the hub to help prevent damage to the out-
board. A strong impact can damage the hub
and propeller blades. Damage to blades can
cause unusual and excessive vibration. Dam-
age to the hub can cause excessive engine
RPM with little forward movement.
IMPORTANT: Avoid or limit operation using a
damaged propeller. Carry a spare propeller.
Keep your propeller in good condition. Use a
file to smooth slight damage to blade edges.
See your Dealer for repair of serious damage.

BATTERY

Requirements
• 12-volt, heavy-duty, designated for "marine"
use;
• Vented/refillable or maintenance-free; and
• Rated according to the minimum require-
ments in Specifications on page 53.
Deep-cycle batteries are suitable IF they
meet or exceed the minimum CCA require-
ments.
Ask your Dealer about your outboard's re-
quirements before installing longer battery ca-
bles or a battery switch.
Installation
Read and understand the safety information
supplied with your battery BEFORE you begin
installation.
IMPORTANT: Make sure all components are
clean and free of corrosion.
Connect the RED (+) cable to the positive (+)
battery post first. Connect the BLACK (–) ca-
ble to the negative (–) battery post last.
If you have marine battery posts, install each
main cable on the clamp adapter with a star-
50
washer below it. Install all wires from acces-
sories on the threaded portion of the post.
1. Main cable
2. Starwasher
3. Accessory wires
If you have automotive battery posts, place a
starwasher on the clamp adapter first, then
the main cable, and then the wires from the
accessories.
1. Main cable
2. Starwasher
3. Accessory wires
Tighten all connections securely and coat the
installation with Triple-Guard grease.
WARNING
Keep the battery connections clean,
tight, and insulated to prevent their
shorting or arcing and causing an
explosion. If the battery mounting
system does not cover the connec-
tions, install covers. Check often to
see that connections stay clean and
tight.