Trailering - BRP Evinrude E15D Operator's Manual

Using Your Evinrude E-TEC Outboard

TRAILERING

WARNING
Keep everyone clear of stern area
when raising or lowering the out-
board. Personal injury or death can
result from contact with moving
parts of the outboard.
Trailering Bracket
To engage bracket — Tilt the outboard fully
using the tilt switch inside the boat or the
trailering tilt switch (on port or starboard side
of engine, depending on configuration).
1. Trailering tilt switch
2. Tilt switch inside boat
Pull down the trailering bracket (see "A" be-
low). A detent will hold the bracket in position.
Lower the outboard until the trailering bracket
locks into place in the stern brackets (see "B"
above).
28
To disengage bracket — Tilt the outboard
fully. Return the trailering bracket to its
stowed position. Lower the outboard to its ver-
tical position.
The outboard is designed to be trailered in a
vertical position or tilted, using the trailering
bracket. Use the position best suited for your
boat.
Manually Tilting
A
If needed, the outboard will tilt up or down
manually, using the manual release screw.
WARNING
Keep everyone clear of a tilted out-
board when backing out the manual
release screw. The outboard could
drop suddenly and forcibly. Be sure
to tighten the manual release screw
after manually repositioning the out-
board. Tightening the screw also
reactivates the outboard's impact
protection and reverse thrust capa-
bility.
B