EUROLIGHT LD6230 IMPORTANT SAFETY INSTRUCTIONS The units installation and initial operation must be done under the supervision of a qualified professional (see INSTALLATION INSTRUCTIONS). To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside;...
Page 3
EUROLIGHT LD6230 EUROLIGHT Professional 6-channel DMX/analog controlled dimmer pack s 6-channel DMX/analog controlled dimmer pack with up to 10 A output per channel s 3-phase mains supply (1 phase possible at lower output power) s DMX512 standard interface for digital control...
4.3 EEP (eprom check) ............9 It is our philosophy to share our enjoyment with you, because 4.4 Phase allocation ............. 9 you are the most important member of the BEHRINGER team. With your highly competent suggestions for new products youve 5. SPECIFICATIONS ............9 made a significant contribution to shaping our company and making it successful.
1. INTRODUCTION The LD6230 requires two height units (2 HU) when installed in As a BEHRINGER EUROLIGHT LD6230 owner, you have a high- a 19-inch rack. Please make sure to leave an extra 4 inches end dimmer pack at your hands. It was designed to answer to (10 cm) of space behind the unit for wiring.
Various LD6230 control elements are described in this chapter. All controls and connectors are described in detail, and you also get useful advice on how to use them in different applications. Fig. 2.1: EUROLIGHT LD6230s front panel Ventilation openings are located on the front panel. Their...
EUROLIGHT LD6230 2.1.4 LIMITER 2.1 Configuration mode When you press the CONFIG key once again, you get to the The important pre adjustments necessary for running the LIMITER menu (the LIMITER LED lights up). Use the CONFIG key dimmer pack are done in the configuration mode. Keeping the to navigate through all six channels.
2.3 ANALOG mode In addition to the digital DMX mode, your EUROLIGHT LD6230 dimmer pack also lets you work in ANALOG mode. You get to this mode by pressing the MODE key while the CONFIG key is pressed (the ANALOG LED lights up).
5 and 6. The LEDs show if correct voltage is 4.1 Digital DMX connector applied to your EUROLIGHT LD6230. If the voltage is not correct (i.e. too high or too low), the corresponding LED(s) begin to blink.