Configuring Rate Limit On A Port - HP 1920 Gigabit Ethernet Switch Series User Manual

Table 159 Configuration items
Item
WRR
Queue
WRR
Setup
Group
Weight
Please select port(s)

Configuring rate limit on a port

1. Select QoS > Line rate from the navigation tree.
2. Click the Setup tab to enter the rate limit configuration page.
Figure 472 Configuring rate limit on a port
3. Configure rate limit on a port as described in
4. Click Apply.
Table 160 Configuration items
Item
Please select an interface type
Description
Enable or disable the WRR queue scheduling mechanism on selected ports. The
following options are available:
•
Enable—Enables WRR on selected ports.
•
Not Set—Restores the default queuing algorithm on selected ports.
Select the queue to be configured.
The value range for a queue ID is 0 to 7.
Specify the group the current queue is to be assigned to.
This list is available after you select a queue ID. The following groups are available
for selection:
•
SP—Assigns a queue to the SP group.
•
1—Assigns a queue to WRR group 1.
Set a weight for the current queue.
This list is available when group 1 is selected.
Click to select ports to be configured with queuing on the chassis front panel.
Description
Select the types of interfaces to be configured with rate limit.
486
Table 160.