Louisiana Grills LG700 Owner's Manual page 9

Step 2 Install the Locking Casters:
The bottom portion of each of the 21" long legs has a threaded plate installed to
allow for the installation of a thread caster.
You will use both threaded locking casters.

Hand install the casters on the 21" (shorter of the two) legs.

Using your 1/2" wrench, turn each of the casters in a clockwise direction
into the bottom leg plate. Turn ALL the way in.
Step 3 Install the Wheel Assemblies
Each 23" long leg has a solid bottom plate, as well as a hole punched through
the leg to accept a wheel axle.
You will use both Wheels, 2 x Axels, 2 x Fender Washers (CC) and
2 Cotter Pins (DD)

Install the wheel assemblies on the 23" (longer of the two) legs.

Insert the axle through the wheel, the leg assembly and finally the
fender washer. (CC)
The wheel should be on the outside edge of the assembly, next the leg
and then finally the fender washer. (CC)

Insert the cotter pin (DD) clip through the hole found at the end of the
axel. Spread the cotter pin ends to secure in place.
Final Step Attaching the Cart to the Barrel

Ensure that when you install the Barrel Smoker onto the Leg Cart
that the Caster Legs are on the hopper end of the grill. This will
give stability to completed unit and allow for easy movement.

Carefully lift the Barrel Smoker up and unto the Leg assembly.
Note: This may require 2 people.
The barrel smoker will slide down and over the leg assembly .
Carefully stand one end of the barrel on a protective floor covering.
Then insert the legs into the barrel. This makes a single person
installation much easier.

Starting at one leg:
Line up the pre-drilled and cinch nut installed holes on the leg,
See diagram for location, and the punched hole on the side of the
smoker. There is one on the front and one of the side of each leg.

Using a Phillips head driver, install 2 of the supplied
Screws (BB) into each leg, to secure each leg to the Barrel.
NOTE: It is best to start each threaded screw by hand, to ensure
the thread DOES NOT cross thread or strip.

When one leg is complete, continue the same steps
On the remaining 3 legs.
Assembly Instruction
INSTALLING THE CART KIT
OR
...CON'T