Cooking Grids; Start Up Procedure; Getting Started - Louisiana Grills LG700 Owner's Manual

Please note that during shipping or moving around on your deck, some movement within the grill may have taken place,
so a complete visual inspection is required. Please follow these Initial Set-Up procedures to ensure the proper and safe
operation of your grill.
TIP
It is a highly recommended practice to always go through these basic SET
UP PROCEDURES, after every 1 to 3 cooking's. This will ensure proper
ignition, heat output and many continuous happy grilling experiences.
Step 1
Open the SMOKER LID and remove the

Cooking Grids (13).

Step 2
Remove the "Arched Flame Broiler" (12).
Clean off any excess food drippings or
grease build-up.
Step 3
Remove the Stainless Steel Burn Grate
(8) and inspect the Burn Pot (9).
Remove any foreign items. Ensure that
the air holes in the grate (8) and the
Igniter (7) are clear of debris.
Note: You can line the bottom of the barrel with
heavy-duty aluminum foil. Line from left to right,
starting from the burn pot area and going
to the Arched Flame Broiler support.
This will make clean-up and general maintenance easier.
Step 4
Re-install the Burn Grate (8). Ensure that the stainless steel grate is sitting down and snug in the burn pot (9)
and that the igniter is lined up properly with the hole in the burn grate. You may have to gently lift up or down on
the igniter to align with the hole.
Step 5
Re-install the "Arched Flame Broiler" (12). The larger piece of the "Arch" should be facing upward and the flame
slots close to the hopper end of the barrel. This then sits on the mounting bracket and grease divider plate.
The slot hooks over the moveable hanging bracket found over the pellet fuel drop area. Ensure that this mount-
ing bracket is snug against the barrel. The second piece of Flame Broiler then fits on the top of the first and
then slide "Closed". If you are cooking anything with a large amount of drippings, you may want to line the
"Closed" Arched Flame Broiler with heavy-duty aluminum foil, to make cleaning easier.
Step 6
Re-install the Cooking Grids (13)
Step 7
Ensure the Grease Bucket (11) is installed, cleaned and ready to go.
Step 8
Open the Hopper Lid (1) and check for any foreign materials. Fill the hopper (2) with your choice of all natural
wood pellet fuel.
Step 9
Plug it in. Start it up. Savor the Flavor !

Getting Started

Set Up Procedure
Digital Control Center
22