Hopper; Powder Coat Finish - Louisiana Grills LG700 Owner's Manual

How the Board Works 101
START-UP mode
Allows electricity to flow to all the electrical components for 20 minutes. This is a software set program that will
automatically start the combustion/cooling fan, the igniter and the feed system at a preset rate, until the grill probe reaches
a temperature of 150°F. Once met, the igniter will shut off and the feed rate is controlled by the control board..
If for any reason the 150°F is not reached in 20 minutes, the control will turn OFF and an ER-2 will display on the screen.
SHUT DOWN mode
When finished "Savoring the Flavor", simply push the OFF touch pad. The control will turn off only the feed system,
allowing the fan to continue to run not only to burn out the fuel, clean and efficiently, but also to cool down the grill. When
the grill probe reaches 130°F the control will shut off completely.
Knowledge is Power
The entire line of LG SERIES Smokers utilize the exact same hopper and component
parts. To increase the life of your grill and its main working component parts the
Combustion / Cooling fan is used to perform 3 main functions:
1. Pressurize the internal hopper compartment to cool the wiring, electrical
component parts and the wood pellets.
2. Forces constant air movement between the hopper and the grill barrel wall.
Because of higher temperatures needed for searing and because of the longer
length of time a pellet grill can operate, such as slow smoking a whole hog, air
movement is used to provide an air barrier between the two surfaces.
Ensure the air slots found on the front and back of the hopper do not get
blocked off, at any time.
3. To provide combustion air, allowing the pellet fuel to burn properly. The fan
forced air is then used to provide "Convection Cooking" within the smoking grill.
Convection cooking locks in the juices and distributes the heat evenly
throughout the grill resulting in that savory flavor and near perfect cooking.
Louisiana Grills uses a "High Heat Powder Coat" finish throughout the entire line of the
Smokers. This High Heat finish is rated for 1000°F. This is done to allow for easy and
trouble free maintenance, and adding to the life of your smoking grill. Powder coating
is environmentally friendly and produces an excellence and superiority of finish that
customers count on. Maintaining the initial appearance of a powder coating is a simple
matter. If the finish does scratch, flake, rust or just needs to be "freshened- up"
it is important to use a touch-up paint ( High Heat BBQ) to repair it as soon as
possible. (see maintenance for further detail)
All LG Smokers use the "Arched Flame Broiler" system that channels any excess
grease, that does not evaporate, directly to a sealed grease catch area. From here any
excess grease is directed to the drop spout where it is disposed in, an easy to clean or
replace, metal bucket. The metal handle of the bucket simply hooks on the notched
out grove of the grease spout. Allow the grease to cool before removing the pail.
TIP:
if you want to replace your grease fill bucket with a new one, save any small
metal buckets that you acquire from yard candles, etc.
All LG Series smokers use a metal screen, mounted inside the hopper, to protect
fingers, clothing or other objects from coming in contact with the moving metal auger.
This screen can not be removed unless directed by Dansons Customer Service or
authorized service personal, to perform service work.
Fan Cooled Hopper

Powder Coat Finish

Grease Catcher
Hopper Screen
.
19