Louisiana Grills LG700 Owner's Manual page 14

INSTALLING THE PORCELAIN COATED GRIDS:
Your LG SERIES Smoker comes complete with 2 or 3
Porcelain Coated Cast Grids for the Main cooking surface.
Your LG SERIES Smoker comes complete with 1
Porcelain Coated Grid for the Upper Cooking Rack.
NOTE: To maintain the searing and grilling performance of your grid, as well as their longevity,
•
some
INSTALLING THE GREASE BUCKET:
Simply place the handle of the bucket into the
slot of the grease drop chute (11).
NOTE: any metal bucket and any size could also be used.
Ensure that the handle can safely clip into the
slotted grease drop.
Tip ! After installing the bucket on the grease drop chute, install
a #3 Hitch Pin up through the drop chute. This will secure the
bucket handle and avoid those accidental bucket spills.
HOOKING UP TO POWER:
AT HOME
This appliance requires 230 Volt, 50Hz, 5 amp service.
•
It must use a 3 prong grounded plug.
•
Both the "Deluxe Temperature Control" and "Digi-Que" controls use a 8 amp fuse to
•
protect the board from the igniter.
GFI Outlets
This appliance will work on most GFI Outlets. Recommended size 15 amp.
•
If your GFI outlet is highly sensitive to power surges, it will very likely trip during the ignition phase
•
of operation. During the ignition phase, the igniter is drawing 300—700 watts of electricity which
can be too much power for a GFI outlet to handle. The quality of the GFI does not matter, rather
the sensitivity matters. Each time a GFI trips it does increase in sensitivity.
Solution: 1.
Install a brand new GFI .
2.
Plug the appliance into a non-GFI outlet.
ON THE ROAD
By disconnecting the Igniter, from the main wiring harness, your LG Series
•
Smoker can be run using a 100 watt inverter plugged into your automobile
outlet. Then light your smoker using the manual method. ( found in
lighting instructions)
If you do want to continue to use the automatic igniter, it is recommended to
•
use a minimum of a 1000 watt inverter.
Assembly Instructions
14