Arched Flame Broiler"; Installing Handle; Installing Thermometer - Louisiana Grills LG700 Owner's Manual

INSTALLING THE "ARCHED FLAME BROILER":
 To ensure proper height, the bottom of the mounting bracket (A)
should not be within the pellet drop chute area.
If you do need to adjust the bracket, loosen off the 2 (two)
Phillips screws, lift the bracket and re-tighten the screws.
 Take the Arched Flame Broiler ( C) and hold it so that the end with
the cut out and slots is in your left hand. The plate then clips
easily over the adjustable mounting bracket. (B)
 Take the Arched Flame Broiler Cover Plate (D) and place it on
top of the main piece ( C). This plate is used to slide
over the flame broiler opening, to open or close "Diirect"
flame searing.
INSTALLING THE HANDLE:
Tools Required:
Phillips Screw Driver
2 x 1/4-20 x 3/5 in Screw (AA)
Insert one scew through the hole provided in the barrel

Install the LARGE Decorative Washer, then the

smaller washer on the screw end sticking through the
barrel.
 Hand thread and tighten this screw to one of the ends
of the one piece stainless steel handle. .
 Follow the same procedure to secure the other end of the handle to the barrel.
 Using a screw driver firmly tighten both bolts until handle feels firm.
CAUTION!
DO NOT OVERTIGHTEN! Only a snug fit is required.
INSTALLING THE THERMOMETER:
The thermometer comes complete with its own threaded nut
already installed on the thermometer.
 Simply spin off the threaded nut and small washer.
• Insert the Dome thermometer, along with the large finiishing washer as
well as the protective felt, through the hole provided in the top of the
hood,
•
Then firmly hand tighten the nut back onto the thermometer.
Assembly Instructions
9/16" Wrench
A
D
Handle
Small Washer
Large Decorative
Washer (Bezel)
1/4"-20 x 3/5"
Machine
Screw (AA)
Dome Thermometer
Large Protective Felt
Large Finishing Washer
Washer & 9/16" Nut
13