Louisiana Grills LG700 Owner's Manual page 11

INSTALLING THE HOPPER, IGNITER & PROBE WIRE
Step 3 Attaching the hopper to the barrel:
The mounting bracket on the rear of the hopper (B) must be raised
•
slightly higher then the receiving bracket on the barrel. (A)
Diagram A & B
Begin by slightly inserting the igniter into the installed Burned Pot
•
at the bottom side of the barrel.
Next slightly insert the Auger Feed tube into the correct hole.
. It might be necessary to raise the hopper slightly to ensure the
mounting bracket on the hopper will go over the receiving
bracket on the barrel.
Push Hopper tightly against the main barrel.
•
Next holding the hopper fairly level, press downward to clip the
hopper onto the mounting bracket. Diagram C & A
Using your phillips screwdriver and the
•
6 1/4x20-1/2" screws (BB), secure hopper to barrel
through the holes provided, inside the barrel.
NOTE: If the holes do not line up,
the hopper may need to
be fully clipped into place.
Assembly Instruction
A
Diagram D
B
C
D
11