Series 4C Hopper Assembly; Parts Included; Tools Required - Louisiana Grills LG700 Owner's Manual

Installing the Hopper and Grill Probe

Parts Included:

Series 4C Hopper Assembly

Mounting hardware
2 x #10 x 16 x1/2" screws,
6 x 1/4 x 20 x 1/2" screws

Tools Required:

Phillips Screwdrivers
Installation:
Step 1 Attaching the Igniter to the Hopper:
 Carefully remove the igniter and its packaging from inside
the hopper. Diagram A
 Using your Phillips driver and 2 (two) screws,(BB)
secure the Igniter to the outside of the hopper.
Step 2 Attaching the Grill Probe Wires:
Your Grill/Smoker comes complete with the "Digital Control Center"
complete with grill probe and meat probe. The grill probe has been
factory installed in the barrel, with the excess wire and connections run
out through the barrel end and threaded into the auger feed hole, for
shipping reasons.
Diagram C
The wire connections to the board can be found in or taped to the
outside of the hopper.
 To connect, carefully lift the entire hopper and attached igniter, to
the left hand-side of the main barrel.
 Begin by slightly inserting the igniter into the
installed Burned Pot at the bottom side of the
barrel. Support the hopper on your leg as
you connect the two spade connections.
Diagram E
 Carefully thread ALL excess wire, as well as
the connections, back into the hopper. The
wiring must not come in contact with either
the fan blades, or the metal auger tube.
Diagram F
Assembly Instruction
Diagram D
E
A
B
Diagram B
C
D D
F F
10 10