HP Mini 10 Maintenance And Service Manual page 90

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Service cover (see
●
Keyboard (see
●
Top cover (see
Remove the display assembly:
1. Position the computer upside down, with the front toward you.
CAUTION:
support the display assembly can result in damage to the display assembly and other computer
components.
2. Remove the two Phillips PM2.0×5.7 screws (1) that secure the display assembly to the computer.
3.
Remove the display assembly (2).
NOTE:
models.
4. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a. Flex the inside edges of the top edge (1), the left and right sides (2), and the
bottom edge (3) of the display bezel until the bezel disengages from the display enclosure.
82 Chapter 4 Removal and replacement procedures
Downloaded from LpManual.com Manuals
Battery on page
WLAN module on page
Keyboard on page
Top cover on page
Support the open display assembly when removing the following screws. Failure to
Steps 4 through 9 apply only to Compaq Mini CQ10 and HP Mini 110 computer
50), and then remove the following components:
52)
61)
67)