Cub Crafters CC18-180 Maintenance Manual page 8

REV PAGE NUMBER
F Chapter 12-00: Page 4
Chapter 20-00: Page 7
Chapter 24-00: Page 8
Chapter 27: Page i
Chapter 27-20: All
Pages
Chapter 27-30: All
Pages
Chapter 27-40: All
Pages
Chapter 32-60: Page 3
Chapter 34-00: Pages 6
and 7
Chapter 37-00: All
Pages
Chapter 51-00: All
Pages
Chapter 60-00: Page 2
Chapter 71: Page i
Chapter 71-10: All
Pages
Chapter 71-60: All
Pages
Chapter 74-00: All
Pages
Chapter 76-00: All
Pages
Chapter 79-00: All
Pages
Chapter 80-00: All
Pages
Chapter 95:
Appendix A: Page 5
00
Page: vi
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
CHANGE
Added Engine Controls to
Lubrication Chart.
Added "Inch-Pounds" to General
Torque Values Chart
Revised 5.B.2.b.
Revised Table of Contents to
match GAMA numbering
Created Sub-Chapter for Rudder
Controls
Created Sub-Chapter for Elevator
Controls
Renamed to "Horizontal Stabilizer"
and restructured.
Added Knots information to MPH.
Added Knots information to MPH.
Created Chapter for Vacuum
System (was 71-90)
Revised number to match GAMA
numbering.
Added Note regarding Sensenich
Wood Propeller Model W80CM8.
Revised Table of Contents to
match GAMA numbering.
Revised Sub-Chapter to match
GAMA numbering for Engine Cowl.
(was 71-30)
Revised Sub-Chapter to match
GAMA numbering for Air Induction.
(was 71-20)
Created Chapter for Ignition. (was
71-10)
Created Chapter for Engine
Controls (was 71-70)
Created Chapter for Oil System
(was 71-50)
Created Chapter for Starter (was
71-80)
Revised Chapter Title to "Special
Purpose Equipment".
Revised Speed Table to begin at 0
MPH and end at 180 MPH
DATE PREPARED CHECKED
Manual number TC10000AMM
Date: 12/29/14