Maintenance Practices For Aircraft Equipped With Wipaire 2100A Amphibious Floats; Preparation - Cub Crafters CC18-180 Maintenance Manual

1.2 MAINTENANCE PRACTICES FOR AIRCRAFT EQUIPPED WITH WIPAIRE
2100A AMPHIBIOUS FLOATS

1.2.1 PREPARATION

a. Place the aircraft in a hangar with the doors closed where the wind will not affect
the aircraft.
b. If the aircraft is being weighed, place weighing pads under the front wheels.
c. Install axle extensions P/N TL4000-001. Axle extensions are defined in Section
95-00 of this document.
d. Place the aircraft approximately in a flight level attitude by the rear wheels on
jacks as shown in Figure 08-00-3. If the aircraft is being weighed, place the jacks
on weighing pads.
FIGURE 08-00-3 - Jacking Aircraft with Wipaire 2100A Amphibious Floats
08-00
Page: 4
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
Manual number TC10000AMM
Date: 6/30/14