Cub Crafters CC18-180 Maintenance Manual page 7

REV PAGE NUMBER
E Chapter 05-10: Page 3
Page 4
Chapter 05-20: Page 11 Added Artex Model ME406 ELT
Chapter 06-00: Pages 5
& 6
Chapter 08-00: All Pgs
Chapter 12-00: Page 3
Chapter 20-00: Page 6
Chapter 27-30: Page 4
Page 12
Page 14
Chapter 27-40: Page 2
Page 3
Page 4
Chapter 28-00: Page 3
Page 4
Page 10
Chapter 32-00: Page 3
Chapter 32-20: Page 2
Chapter 32-41: Page 2
Page 6
Chapter 34-00: Page 5
Chapter 60-00: Page 2
Chapter 71-00: Page 2
Chapter 71-10: Page 2
Chapter 95-00: Page 2
Appendix A: All Pages
F All Chapters and All
Pages
Chapter 00: Page vii
Chapter 05-00: Page 3
Chapter 08-00: Page 8
and Page 9
Chapter 10-00: Page 4
Manual number TC10000AMM
Date: 12/29/14
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
CHANGE
Added O-360-C1G Engine
Added Artex Model ME406 ELT
Revised Wipaire callout to "2100A"
Revised Wipaire callout to "2100A"
Revised Fuel Capacity on Table 1.
Corrected torque value for Spark
Plugs: 415-425 in-lbs. was 400-
420.
Added double cotter pin to clevis
pin installation on Rudder
Clarified (g) for tab location.
Added double cotter pin to clevis
pin installation on Elevator.
Clarified A(c) for levelling aileron.
Clarified B(c) for levelling Elevators
Clarified C(c) for levelling Rudder
Revised Figure 28-00-1.
Revised Troubleshooting Chart.
Revised Fuel Check Valve
information.
Revised Tail Wheel "Remedy"
Revised Figure 32-40-1 for 2-hole
configuration shown.
Revised General Information.
Removed tire pressure callouts
Reference to 43-10 removed from
Airspeed Indicator Remedy.
Revised Propeller Options.
Added O-360-C1G Engine Option
Revised General Section to
remove C4P Reference.
Revised Wipaire callout to "2100A"
Added to Manual.
Revised all references to match
new chapter and sub-chapter
numbering.
Revised Table of Contents.
Revised Note.
Added note to clarify arm
measurement for floats. Revised
Table 08-00-6.
Revised 3.B.1.g for Propeller
cleaning.
DATE PREPARED CHECKED
4/15/08 SJT / JPB
05/20/08 SJT
SJH
SJH
00
Page: v