Cub Crafters CC18-180 Maintenance Manual page 382

1. GENERAL
The CC18-180 aircraft requires special tooling for the service and maintenance of the aircraft.
This section lists general tools needed for the service and maintenance of the aircraft.
2. TOOLING
A. TL4000-001 FLOAT AXLE EXTENSION
The CC18-180 aircraft may have the option of being fitted with Wipaire 2100A Amphibious
Floats. In the event that the aircraft is fitted with floats a special tool is required for jacking
the aircraft. Refer to section 08-00 for the proper use of the tool. The float axle extension
tool is used to jack the aircraft, in particular when it is weighed following the procedures
outlined in section 08-00 of this manual. The axle extension is inserted in the round tube on
the inboard side of each main landing gear. The axle is to be made out of low or mild carbon
steel. Figure 95-00-1 shows the dimensions of the tool to be used to lift the rear axles of the
float equipped aircraft.
95-00
Page: 2
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
"
Figure 95-00-1 - TL4000-001 Float Axle Extension
"
Manual number TC10000AMM
Date: 04/16/08