Cub Crafters CC18-180 Maintenance Manual page 369

(g) Attach the forward end of the front brace (a) to the end of the long rocker cover
screw (b) of cylinder #4, securing it with a washer (d) lock washer (c) and nut (f)
and torque to 50 in/lbs. maximum. Secure the rear end with a bolt (h), washers
(i) and nut (j) and torque to 38-43 in/lbs.
(h) Torque the inboard brace bolts on the accessory case to 96 in/lbs maximum and
bend lock-tabs to safety.
(i) Torque the four through-bolt nuts to 38-43 in/lbs.
(j) Attach the longer oil hose to the upper elbow (which points down) on the oil
cooler and tighten the fitting to 55-65 in/lbs while holding the elbow with a
wrench.
(k) Connect the inboard end of the hose to the lower elbow on the accessory case
and tighten the fitting to 55-65 in/lbs while holding the elbow with a wrench.
(l) Attach the shorter oil hose to the elbow that is pointing up on the oil cooler and
tighten the fitting to 55-65 in/lbs while holding the elbow with a wrench.
(m) Connect the inboard end of the hose to the upper elbow on the accessory case
and tighten the fitting to 55-65 in/lbs while holding the elbow with a wrench.
Manual number TC10000AMM
Date: 05/20/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
79-00
Page: 13