Cub Crafters CC18-180 Maintenance Manual page 367

Refer to Figure 79-00-6, Figure 79-00-7, Figure 79-00-8, and Figure 79-00-9.
(a) Apply thread sealant (EZ TURN Lubricant) to all but the most inner pipe thread
on each elbow but not on the flare fitting threads. Screw the elbows (1) into the
oil cooler (2). Be very careful to start the threads properly and tighten as close to
110 in/lbs as possible with the elbow pointing the proper direction.
(b) Position the oil cooler (2) and install the outboard through-bolts (3) with a washer
(4) through the long spacer tubes (7) between the oil cooler webs securing each
with a washer (4) and nut (5).
(c) Position the lower bottom brace (A) and insert the inboard bolt (B), washer (C),
and locktab (D).
(d) Insert the through-bolt (3) with a washer (4) through the short spacer tube (6)
between the oil cooler webs and brace end securing it with a washer (4) and nut
(5).
Manual number TC10000AMM
Date: 05/20/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
A - Lower Brace
B - Bolt
Figure 79-00-7 - Oil Cooler Support Braces
I - Lower Brace
II - Bolt
Figure 79-00-8 - Oil Cooler Support Braces
C - Washer
D - Locktab
III - Washer
IV - Locktab
79-00
Page: 11